If your John Deere Gator won’t start but it turns over, you have probably noticed that the fuel level is low. To check this, you may need to fill the tank. Then, check the oil and battery. If they’re fine, check for blown fuses and fuel filters. If none of these are the problem, the starter motor is probably blown.
blown fuse
When your John Deere Gator won’t start but turns over, you may suspect a blown fuse. Check the battery to ensure the cables aren’t corroded. If you see corrosion, remove the battery access panel by pulling the latch underneath the passenger seat. Clean the terminals with a wire brush and grease them properly. Replace the battery access panel if necessary. If you’ve tried this and still can’t start the Gator, you may need to replace the battery cables.
If you don’t notice any symptoms after a few days, the spark plug might be bad or corroded. If the spark plug isn’t firing, you may need to replace it or install a new one. If you can’t locate a new spark plug, you can consult a mechanic. He will be able to diagnose the problem.
blown fuel filter
Your John Deere Gator may be having trouble starting. There are several reasons why the engine may not crank and may not turn over. Whether the engine is corroded or plugged with sediment, a blown fuel filter can cause the engine to fail to start. If your John Deere Gator doesn’t start but turns over, the fuel filter is likely the culprit. To replace the fuel filter, follow these simple steps.
Before you replace the fuel filter, make sure to check the fuel level by checking the dipstick. You can do this by using a hand dipped in fuel and turning the key. This should start the engine and run for at least a few seconds. You can also check to see if the carb bowl solenoid clicks each time the key is turned. If the solenoid is loose, you can gently remove it with your fingers.
blown starter
If you’ve tried several different ways to jump-start your John Deere Gator without any success, you might be looking for a solution to a problem that keeps cropping up. If the engine is cranking but not turning over, it’s possible the battery is the issue. If this is the case, it may be time to replace the battery. You can also check the fuse.
To replace the spark plug, open the fuel and air valves and inspect the spark plug. If it shows a small hole, the spark is not firing. Other possible causes of this problem include a faulty ignition or a blown fuse. For further troubleshooting, you may need to take your Gator to a mechanic. A mechanic will know how to fix the problem and can make the necessary repairs.
blown starter motor
If you’ve noticed that your John Deere Gator won’t crank but produces a click when you turn the ignition key, you may have a blown starter motor. While there are several common reasons for this problem, here are some possible fixes. A faulty starter motor may be a sign of a battery or ignition switch problem. If it is the starter, try replacing the faulty fuse. If that doesn’t fix the problem, check the battery terminals.
If you have the ohm meter, you can use it to check the starter’s connections. Check the cable from the starter solenoid to the battery. If the cable is loose, a blown starter may also be the cause. Check the connection of the starter’s wiring at the top back of the engine. Check all fuses and tighten them if necessary. Also, make sure that the terminals of the battery are clear of any corrosion.